Adhesive for parquet Tarkett SK100 14kg

SK 100 is a hybrid, one-component, solvent-free adhesive, suitable for:
• Multi-layer parquet up to 15 mm thick, boards up to 2283 mm long, up to 194 mm thick.
• SK 100 is used to a limited extent for solid wood parquet, such as mosaic parquet 160 x 22 x 8 mm. Approval from the technical department is required.
SK 100 can be used for all of Tarkett's multi-layer floors

DIRECTIONS FOR USE
Use a notched trowel to apply SK 100 evenly to the floor, immediately place the floor element onto the adhesive bed
and tap it into place. Remove any spilled adhesive from the parquet immediately, for example with polishing wax. Follow
the instructions given by the parquet manufacturer, paying special attention to the installation instructions and the adhesive
properties of the floor being used.

Recommended trowel notch size:
Consumption depends on the dimensions of the parquet and the shape of the notch used for it.

• Mosaic and two/three-layer pre-finished (oiled or lacquered) parquet (8 mm
  thick, up to 40 cm long) B3: approx. 850 g per m²,
• Short two/three-layer pre-finished (oiled or lacquered) parquet element
  (up to 120 cm) B11: approx. 1200 g per m²,
• Two-layer pre-finished (oiled or lacquered) plank parquet (up to
  230 cm max), three-layer engineered plank parquet (up to 230 cm max) B15: approx.
  1350 g per m².

The notch shapes listed above are indicative only – the final choice of notch shape will be determined by the exact
site conditions and depends on the smoothness of the subfloor, the length of the parquet elements and the condition of the underside
of the parquet. In any case, make sure the back of the parquet is always sufficiently covered.